Add: Jin Tai Lu Dong, Jining Jinxiang County Economic Development Zone, Shandong Province, China
Contact: Li Guopan
Wheel hydraulic motor
The cycloidal wheel motor is used to drive the motor of the vehicle. The general form is to connect the flange stop to the middle part of the motor.
1. It adopts the design of rotor, which is efficient.
2. Radial bearing of wheel hydraulic motor can withstand high radial force.
3. Reliable shaft seal design, can withstand high voltage, can be connected in series and parallel.
4. Positive and negative conversion to convenient and stable speed.
Can a cycloidal motor bear the radial force?
The answer is yes, the cycloidal motor can withstand the radial force. The motor output shaft of shaft distribution oil is used with deep groove ball bearing or Angle contact bearing, while the disc oil motor USES a pair of tapered roller bearings which can withstand greater radial force.
And some of the company's production of motor especially small motor used in bearing flat needle roller bearing, the motor can't bear radial force, so be sure to ask when the order, otherwise, the motor is easy to damage. But the radial force of the cycloidal motor is not infinite and should be checked by the chart. This diagram is just one of the wheel motors, and the rest of the wheel motors are on the sample.
Can the standard cycloidal motor drive the wheels directly?
Since the motor can withstand the radial force, the standard cycloidal motor (that is, not the wheel motor) can also directly drive the chain wheel, gear, wheel, roller and other transmission mechanism. Like some small excavator chassis walking drive is the use of the cycloidal motor driving the track directly. The rolling brush is also used as a wheel motor.